Disk Boot Error can be resolved by Hard Drive Recovery

In modern hard drives the high rotating speed of the hard drives is increasing by bounds and leaps and this can cause hard drive failure. This behavior causes critical data loss and require hard drive data recovery solutions to retrieve data if the backup is not there.
The boot-failure messages indicate the failure of hard drive. For example you might get the following error:

“Disk Boot Error, Replace and Strike Key to Retry”The BIOS (Basic Input/Output System) is not able to recognize the hard drive.

The above error message indicates that your hard drive has some physical problems and hard drive data recovery software is required to handle it. But before you go for some hard drive recovery procedure, please check the following :

• Your system may be trying to boot from other disks inserted into it like floppy in drive A.
• So remove all the drives and try to reboot the system.
• Check BIOS settings.
• Make sure that the hard drive settings are correct and the hard drive is enabled. Verify the boot order.

Mark the primary partition as active.

Make sure that the hard drive power connector and ribbon cables are properly connected.
Examine that all the device drivers are installed.

If the above methods are not successful then switch your system off and consult some expert recovery professional to repair the hard drive and retrieve all the data from it. Please don't open the drive in free environment otherwise it may lead to a permanent data loss.

Stellar Information Systems Limited is the pioneer service provider in the field of hard drive recovery. The service is delivered by skilled and experienced recovery through Class 100 Clean Rooms. Service is provided for all IDE, EIDE, SATA and SCSI hard drives.